Camera Control (2) (For Table Mode 1) - Panasonic LP-ABR11 Setup And Operation Manual

Term Command
Image IPFUNC0=
Preprocessing a,b,c,d,e
Mirrored image MIRROR=a
Thinning
SKIPCAP=a
captures
Image rotation ROTATE=a
7.5

Camera Control (2) (for Table Mode 1)

Term Command
Camera AGC=D
COntrol Mode AGC=T
Number of ENABLEDDMTB
Tables L=a
Editing Table
EDITDDMTBL=a
number
Copy Table CPDDMTBL=a,b
settings or a,b-c
Operation of STARTDDMTBL
Table Mode 1=a
Description
Set the type of preprocessing to captured images
a,b,c,d,e : Preprocessing commands(Described later)
a,b,c,d,e =0,0,0,0,0 (*)
Up to 5 stage of function can be set by CSV
a=0; Read only normal type (not mirrored) (*)
a=1; Read only mirrored type
a=2; Read normal type and mirrored type
Thinning process of captures
a = 0 Disable thinning captures(*)
a = 1 Enable thinning captures (no interpolating)
a = 2 Enable thinning captures (with interpolating)
Enable/disable image rotating (180a) at capturing images
a=0 : Disable rotating (*)
a=1 : Enable rotating
Description
Set in Table Mode (*)
Use the camera setting in Table Mode
a : 0 to 8 a=8 (*)
In case of a=3, Table #1, #2, #3 are enabled and Table #4 through $8
are disabled. In case of a=1, Table #1 is enabled. The shutter speed,
digital gain, and setting of the illumination are fixed to one and it
operates equivalent to the AGC = D.
Edit a table with specified number.
a : 0 to 8 a=0 (*)
T
e.g.) o set the DDMwindow of table #3 to (1,1), enter the following
command.
EDITDDMTBL=3
DDMwindow=1,1
Subsequently, to set the DDMshutt to 5, enter the following command.
DDMshutt=5
To change the table to edit to #4, enter the following command.
EDITDDMTBL=4
The settings of Table #a are copied to Table #b.
The settings of Table #a are copied from Table #b through Table #c.
Specify the operation of Table Mode
a = 0; Start reading from the table number that decoded last. If the
decode failed, start reading from the next table number. (*)
a = 1; Start reading always from Table #1
84
(*)=Default
(*)=Default