Communication - Panasonic LP-ABR11 Setup And Operation Manual

7.1

Communication

Term Command
Baud rate BAUD=aaaa
Frame FRAME=0
FRAME=1
FRAME=2
FRAME=3
FRAME=4
FRAME=5
FRAME=6
FRAME=7
FRAME=8
FRAME=9
Header HEAD=a
Terminator TERM=a
Command CMDFORM=0
Format CMDFORM=1
Separator SEPA=a
Prefix PREFIX=a
Suffix SUFFIX=a
RS/CS control RSCS=0
RSCS=1
TCPCS=0
TCP/IP arrival
confirmation
TCPCS=1
COM Port
COMFROM=0
(Sync
COMFROM=1
command, Data
COMFROM=2
output)
Control Code LABELTX=0
LABELTX=1
Timeout period TXWAIT=a
(*1) Refer to "7.15 Table of Character Code"
Description
Baud rate of RS-232C
aaaa=1200; 1200bps,
aaaa=4800; 4800bps,
aaaa=19200; 19200bps,
aaaa=57600; 57600bps,
7 bits, Odd, Stop bit 1
7 bits, Odd, Stop bit 2
7 bits, Even, Stop bit 1
7 bits, Even, Stop bit 2
8 bits, None, Stop bit 1 (*)
8 bits, None, Stop bit 2
8 bits, Odd, Stop bit 1
8 bits, Odd, Stop bit 2
8 bits, Even, Stop bit 1
8 bits, Even, Stop bit 2
Header character
a=0; None (*)
Terminator character
a=0; None
a=3; [CR][LF] (*)
a=6; [TAB][CR]
Command+[CR] or Command+[CR][LF] (*)
[Header]+Command+[Terminator]
Character code
a=0; None
a=2; , (Comma) (*)
a=4; [GS] (1D hex)
Prefix character
=a,\bb a=0; Disable (*)
bb; Suffix character(Hexadecimal code (*1) bb=00(*) [NUL]
When omitting "bb", configured identifier will not changed.
Suffix character
=a,\bb a=0; Disable (*)
bb; Suffix character(Hexadecimal code (*1) bb=00(*) [NUL]
When omitting "bb", configured identifier will not changed.
Disable RTS/CTS flow control (*)
Enable RTS/CTS flow control
Disable data arrival confirmation (*)
Enable data arrival confirmation
RS-232C only (*)
LAN only
RS-232C and LAN
Pass through (*)
Change Control code to ASCII code within [hex].
Timeout period for decoded data
a=1000 to 2500 [ms]; 10[ms] step
a=1; [SX]
a=1; [EX]
a=4; [CR]
77
(*)=Default
aaaa=2400; 2400bps,
aaaa=9600; 9600bps, (*),
aaaa=38400; 38400bps,
aaaa=115200; 115200bps,
a=2; [EC]
a=2; [EX][CR]
a=5; [CR][TAB]
a=1; &
a=3; [FS] (1C hex)
a=5; [SP] (20 hex)
a=1; Enable
a=1; Enable
1000[ms] (*)