When the reading is successful, the reader uses the table setting in the next reading.
When the reading is failure, the reader attempts to read using the next table setting.
The flow chart of Table mode is shown below.
< Flow char of Table Mode >
Trigger
Read OK?
No
Increment table number
Read OK?
No
Use the first table in the next reading
4.4.1 Edit Table
Edit tables using serial commands.
(1) Set the target Table #.
Send the serial command below to assign the table number to be edited.
(2) Configure the parameters.
Refer to section "4.1 Configuration parameters" for detailed information.
(3) Edit another table
Repeat the step 1 & 2.
(4) Check the target Table
You can check the target table status using the following command.
Yes
Yes
EDITDDMTBL=a (a: 1 to 8)
?ddmtbl
47
Use this Table
Use the next table