Fail To Communicate Through Tcp/Ip Protocol - Panasonic LP-ABR11 Setup And Operation Manual


Is the print quality of the symbol good?
Make sure the quality of the symbol (1D: Module width and
, 2D: Cell size) meet the standards.
width ratio
9.3

Fail to communicate through TCP/IP protocol

Fail to communicate through TCP/IP protocol due to accidental
unplug/plugin of the LAN cable while the reader is in working mode.

Retry the connection process after disconnection.
To recover the connection, send the command "discon" through RS232C
interface for forced termination, and then retry the connection.
Refer to the section "6.6 Manage Commnunication Status"
If there is anything unclear or if you have any problems that can not be resolved
by the above check, contact our sales representative.
102
Wide/Narrow bar