Atlas Copco Power Focus 4000 Graph Quick Manual page 6

The Compact user interface
Button
Question mark
F
F1 / Ft
F2 / tunE
F3 / tool
F4 / Pset
F5 / batS
F6 / DISC
F7 / stun
F8 / Stun
AutoSet
Functionality
Pressing it will show RBU type (Au = Gold, Ag =
Silver etc), installed software release, connected
tool type, active Pset and Job
Press F (Function key) to display functions. To
display function F1 press F once, to display
function F2 press F twice etc. Press Enter to
access and edit a function. When fi nished, press
F repeatedly to display result mode again (or
else it will take 30 seconds for the screen to
update automatically)
Note: The functionality is dependent on the RBU
version.
Final target
Torque tune factor (DS mode only)
Motor tuning. Press and hold the tool trigger
until "done" is shown
Change the Pset (in cases where this has been
enabled)
Set the batch size (0 to 99)
Disconnect tool. Await "Safe to disconnect"
before disconnecting
Sync motor tuning. The LH no. shows the
percentage of sync members already tuned.
The RH no. shows the progress of the ongoing
tuning
Controller IP address. Restart the PF after
changing the address
Start AutoSet, set the target torque and
make tightenings on the actual joint to let the
controller program the tightening parameters
6