Screen Page "Drive Status - Beckhoff AX2000 Setup Manual

Driver software installation digital servo amplifier

Hide thumbs Also See for AX2000:

Table of Contents

Screen page "Drive status"

Run time

ASCII: TRUN

Display of the operational time of the servo amplifier, saved at 8 minute intervals. If the 24V-supply is switched

off, maximum 8 minutes of operation are unregistered.

Last 10 faults

ASCII: FLTHIST

The last 10 faults that occurred are displayed, together with the time of their occurrence, referred to the

operating hours.

Rate of occurrence

ASCII: FLTCNT

Display of the frequency of all faults that caused the servo amplifier to switch off.

Actual errors

ASCII: ERRCODE

Display of the errors presently being reported by the servo amplifier (corresponds to the error messages Fxx in

the LED-display on the front panel of the amplifier)

Actual warnings

ASCII: STATCODE

Display of the warnings presently being reported by the servo amplifier (corresponds to the

warnings nxx in the LED-display on the front panel of the amplifier)

Reset

ASCII: CLRFAULT

Software-reset of the servo amplifier. The servo amplifier must be disabled.

Present errors are deleted, the firmware is re-initialized, and communication is re-established.

If only errors marked with an asterisk in the error listing are present, then the errors are canceled, but no reset

of the amplifier takes place.

07/03

Default: -

valid for all OPMODES

Setup Software

BECKHOFF

Table of Contents