Table of Contents
Advertisement
Screen page "Amplifier"
8
Screen page "Amplifier"
This screen page displays the control loops of the servo drive in a simplified block diagram. A click with the left
mouse button on a button on the screen page calls up the corresponding function or screen page.
Save the current parameter to data media (hard disk, diskette). You can save parameters and motion task data
to one single file or to separate files.
Load a control parameter file or a motion-block parameter file from data media
(hard disk, diskette). The servo amplifier must be disabled to do this.
Open the screen page "TERMINAL" for the direct input of ASCII commands
(only for advanced users, and with the support of our application department).
Open the screen page "ACTUAL VALUES" to display the actual drive status.
Open the screen page "OSCILLOSCOPE/SERVICE" for the graphic display of the setpoint/actual values, and
to access the service functions (reversing mode, const. speed etc.) for optimizing the amplifier.
Open the screen page "Bodeplot". This page makes it possible to use a Bode plot generator to generate a
graphical representation of the behavior of the speed controller.
Non-volatile (does not disappear at power-off) storage of the currently valid parameter set in the EEPROM of
the servo amplifier. In this way you can permanently save all the parameter changes that you have made since
the last switch-on/reset of the servo amplifier.
ASCII: SAVE
Stop the currently active service function. This is the same as using the function key F9.
Stop (cancel) motion functions in the OPMODES 0, 2 and 8.
Movements in other OPMODES can only be stopped by using the DISABLE button.
Cancel all the parameters that have been set up, and load the manufacturer's default values.
Making a hardware-reset
ASCII: COLDSTART
26
07/03
Default: -
Default: -
BECKHOFF
valid for all OPMODES
valid for all OPMODES
Setup Software
Advertisement
Table of Contents
