Program Delay; Info Mode - VET-PRO VIP 2000 Operator's Manual

Pressing 5 times on the info key during PCA
operation will display the time and date.
To clear the volume infused (VI): press the info
key to display the volume infused (from stop or
setting mode) and then the STOP/NO key. The
screen will change to show volume infused zero.
Pressing the STOP/NO key after the program is completed , will erased the
VI. The option to erase the volume infused through info, is used in case the
last program was not completed.
F
Note:

Program Delay

Delay of the program before the start is enabled in the Continuous
program (both in rate over volume and in volume over time), TPN and
the 25 steps program.
To enable delay before start option, set delay
before start to on,
(Adjust Setting). After setting the program data
the pump will enable the delay setting.
Use the numeric keys to set the time delay (up
to 20 hours).
At this stage, if no value was set, pressing the
START/OK key
operation with no delay.
48
Exit from the info mode is automatic after 10 sec, or can
be achieved by pressing the info key.
as described on page 48
wil start the
Time 8:30
Date 24.03.02
Infused
C
Volume 250ml
O
N
Press OK for Delay
T
C Rate
O Volume
N Time 10:00
T Press OK for Delay
Time Delay 15:00
Press OK to start
program
VET-PRO Operator's Manual
ml
25 ml/h
250ml