VET-PRO VIP 2000 Operator's Manual page 31

Program Setting
F
Note:
: -If one of the values is changed during the programming
Note
The pump will display the previous rate for the
.
first step. Set a new rate, using numeric keys,
or confirm pressing START/OK.
Pump will display the previous volume for first
.
step. Set a new volume, or confirm pressing
START/OK key.
Pump will display the rate for step 2. Repeat directions as for step 1 and
3.
repeat through all the steps required, up to 25.
After last required step, set rate to zero. This
4.
indicates that all data required for the protocol
has been set. All protocols following the last
set protocol, will be automatically zeroed
.Press START/OK to confirm.
After last step rate was set to zero or after 25
5.
steps are completed, the pump will display the
accumulated data setting, to enable comparison
and verification. Press START/OK to start the
program or STOP/NO to scroll through all the
protocol settings again.
Setting Program Delay– Refer to page 48.
During the program operation, the display
6.
updates the user on which step the pump is
running.
F
Note:
VET-PRO Operator's Manual
Whenever you decide to set a new program, follow the
instructions at the bottom of the screen.
mode, the pump will not store the new value, unless changes
are confirmed by pressing the START/OK key.
-If the flush key is activated during data setting, the pump
will return to the original (previous) screen, once flushing is
completed.
Pressing the STOP/NO key shall erase the last digit. Once
no digit is displayed, pressing the STOP/NO key will
change the screen to show the previous display.
Step 1 Rate
100 ml/h
Press OK for Volume
Step 1 Volume
1000 ml
Press OK to continue
Step 11 Rate
0 ml/h
Press OK for Volume
Total Steps 10
Total Volume 5000ml
Press OK to start
S Rate Step 1 of 10
T
E
100 ml/h
p
31