Table of Contents
Advertisement
Installing the rear shield
About this topic
Before you start
Installing the rear shield
G5562A, G5563A Bravo Platform Safety and Installation Guide
Read this topic if you have a Bravo Platform that will be operated in an area
where access to the moving parts is possible through the rear opening in the
backplate. This topic describes how to install the rear shield to protect
operators from moving- parts hazards while the device is in operation.
The rear shield is not necessary if the back opening of the Bravo Platform is
not accessible to operators, for example, if the back opening is against a wall.
WARNING
To prevent potential injury, turn off the Bravo Platform and disconnect the
power cord before you install or remove any accessory.
Make sure that you have the following:
•
Rear shield kit
•
Cross- tip screwdriver
•
2.5- mm and 3- mm hex wrenches
•
T10 and T20 Torx drivers
The following figure shows the installed rear shield, which is a clear panel that
blocks rear access to the deck through the opening in the Bravo backplate.
Figure Bravo Platform with rear shield installed
00220
Bravo
Back
2 Installing the Bravo Platform
Installing the rear shield
45
Advertisement
Table of Contents
