Table of Contents
Advertisement
2 Installing the Bravo Platform
Installing the rear shield
Installing the rear shield
About this topic
Before you start
Installing the rear shield
44
For information about...
Moving- parts hazards
How to set up and operate the
Bravo Platform
Read this topic if you have a Bravo Platform that will be operated in an area
where access to the moving parts is possible through the rear opening in the
backplate. This topic describes how to install the rear shield to protect
operators from moving- parts hazards while the device is in operation.
The rear shield is not necessary if the back of the Bravo Platform is next to a
wall or if the device is operated inside an enclosure.
WARNING
Turn off the Bravo Platform and disconnect the power cord before you
install or remove any accessory.
Make sure that you have the following:
•
Rear shield kit, including two clamps, one M3 screw and four M4 screws
•
Cross- tip screwdriver
•
2.5- mm and 3- mm hex wrenches
The following figure shows the installed rear shield, which is a clear panel that
blocks rear access to the deck through the opening in the backplate.
See...
"Mechanical hazards" on page 8
Bravo Automated Liquid Handling
Platform User Guide
Bravo Automated Liquid-Handling Platform User Guide
Advertisement
Table of Contents
