VS Series Helium Mass Spectrometer Leak Detectors
1.6 Rear Panel
The rear panel of the leak detector with an external mechanical pump (Model VS MR15 or
MD30) and a wireless remote control option is shown in Figure 1-9.
➀
Serial Connector
➁
Cover Plate
➂
Power Entry
Module
➀
10
11
Figure 1-9 VS Series Rear Panel
A 9-pin male D-type connector to interface with an external PC via
RS-232 type communications protocol for system diagnostic or
control.
A detailed summary of information related to serial communication
is provided in Section A "Communications Protocol" on page A-1.
Access to expansion slot. This is not used when an optional I/O
PCB is installed. A rear panel of the optional I/O PCB is shown in
Figure 1-10 on page 1-20.
Provides supply power, overcurrent and EMI protection for the leak
detector. The Power Entry Module consists of:
❑
Power Input Connector - An IEC/EN60320/C20 standard,
three-prong grounded Inlet connector.
❑
Power Switch (I/O) - A 20A rocker type Power
Switch/Thermal Circuit Breaker.
❑
20 A EMC line filter.
7
➀
9
➅
➄
12
➁
8
➂
➃
➁
1-19