Table of Contents
Advertisement
2 Installing the Bravo Platform
Installing the rear shield
46
To install the rear shield:
1
On the side of the Bravo Platform, press the power switch to the off (o)
position (1), and unplug the power cord (2). See the following figure.
Figure Bravo Platform rear view
1
2
At the back of the Bravo Platform, remove the screw from the center lower
edge of the rear cover (3), as the preceding figure shows.
Save the screw for future use in case the shield is removed.
3
If applicable, route tubing or cables from any on- deck accessories through
one of the three deck- access windows in the rear shield.
4
While holding the shield in place to cover the rear deck opening, use a T10
driver to install the screw (M3) at the top center of the shield into the
screw hole in the Bravo backplate.
5
At the bottom of each Bravo backplate post, position a shield clamp on the
interior. See the following figure.
2
3
00220
Bravo
Back
G5562A, G5563A Bravo Platform Safety and Installation Guide
Advertisement
Table of Contents
