Table of Contents
Advertisement
2 Installing the Bravo Platform
Installation workflow
Installation workflow
Before you begin
Workflow
Step
For this task...
1
Verify that the installation location meets the
site requirements.
2
Unpack the computer and connect the
monitor, power, mouse, and keyboard.
3
Install the VWorks software.
4
Unpack the Bravo Platform.
IMPORTANT
5), do not remove the y- axis shipping stop
from the head mount until after you have
installed the risers.
5
If required, install the risers to elevate the
height of the deck. Ensure the y- axis shipping
stop is removed from the Bravo head mount.
6
Install the platepads on the Bravo deck.
7
If applicable, install the deck accessories.
8
Connect the Bravo Platform.
9
Install the liquid- handling head.
10
Install the safety equipment.
12
The Bravo Platform can be installed as a single device controlled by a
computer or integrated with other devices in a lab automation workstation.
For either configuration, ensure that you connect the Bravo safety interlock
circuit to a Bravo light curtain or an enclosure with an interlock switch to
mitigate the risk to users from moving parts.
If the Bravo Platform will be operated outside of an enclosure, install the
Bravo safety equipment, as described in the following workflow.
WARNING
To reduce the risk of injury from moving parts, ensure that the Bravo safety
interlock circuit is connected to a Bravo light curtain or an enclosure with an interlock
switch.
If you are installing risers
See...
"Laboratory setup requirements" on
page 13
Manufacturer's instructions
Software release notes or
Automation Control Setup Guide
Bravo Platform Unpacking Guide
(step
Agilent Automation Solutions Technical
Support
"Installing the platepads" on page 17
Bravo Platform User Guide
"Connecting the Bravo Platform" on
page 18
"Installing the liquid- handling head" on
page 22
"Bravo light curtains and shields" on
page 29
G5562A, G5563A Bravo Platform Safety and Installation Guide
VWorks
Advertisement
Table of Contents
