Table of Contents
Advertisement
G5562A, G5563A Bravo Platform Safety and Installation Guide
Figure Rear shield clamp in position on Bravo backplate post (view from interior)
Note: The clamps are secured in place after the shield screws are
installed in the next step.
6
Using a T20 driver, install the two M4 screws in the rear- facing end of
each clamp to secure the shield to the clamps, as the following figure
shows.
Note: The preferred location for the rear shield clamps is at deck level.
If something interferes with the deck- level position of a clamp, you can
use the optional attachment holes on the shield to position the clamp
higher on the post. In this case, you should keep the second clamp at
deck level if possible.
Figure Detail of screws installed in clamp on rear post
7
Use a T20 driver to install the covers on the three deck- access windows in
the rear shield, unless tubing or cabling access is required. Three M4 8- mm
screws secure each window cover to the rear shield to prevent access
through the window opening.
2 Installing the Bravo Platform
Installing the rear shield
00220
Bravo
Back
47
Advertisement
Table of Contents
