Segger J-Link User Manual page 257

257
11.4.1.4 Production Settings
Enable target power
Enables 5V target power supply via pin 19 of the emulator. Can be used for targets which
can be powered through the emulator for production. Delay before start defines the delay
(in ms) after enabling the target power supply and before starting to communicate with
the target.
Actions performed by "Auto"
The checked options will be performed when auto programming a target (Target -> Auto,
shortcut: F7). The default behavior is Compare, Erase sectors if not blank, Program and
Verify. Find below a table which describes the commands:
Command
Compare
Erase
Program
J-Link / J-Trace (UM08001)
CHAPTER 11
Performs a compare of the current flash content and the da-
ta to be programmed. Sectors which do already match will be
skipped by Erase / Program operation. Note: If Erase is enabled
and Erase type is "Chip", the compare will be skipped as after
mass erase, the entire device is empty and needs to be re-pro-
grammed.
Performs an erase depending on the settings, selected in the
drop down box:
• Sectors: Erases all sectors which are effected by the image to
be programmed.
• Sectors if not blank: Erases all sectors which are both, effected
by the image to be programmed and not already blank.
• Chip: Erase the entire chip independent of the content.
Programs the data file.
Description
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
Settings