Segger J-Link User Manual page 61

61
Remote command
DisableChecks
EnableChecks
flash breakpoints
getargs
go
halt
jtagconf
memU8
memU16
memU32
reg
regs
reset
semihosting breakOn-
Error
semihosting enable
semihosting IOClient
semihosting ARMSWI
semihosting ThumbSWI
setargs
setbp
sleep
speed
step
SWO DisableTarget
SWO EnableTarget
SWO GetMaxSpeed
SWO GetSpeedInfo
waithalt
wice
The Following remote commands are deprecated and only available for backward compat-
ibility:
Remote command
device
interface
speed
Note
J-Link / J-Trace (UM08001)
CHAPTER 3
Do not check if an abort occurred after memory read
(ARM7/9 only).
Check if an abort occurred after memory read (ARM7/9 on-
ly).
Enables/Disables flash breakpoints.
Get the arguments for the application.
Starts the target CPU.
Halts the target CPU.
Configures a JTAG scan chain with multiple devices on it.
Reads or writes a byte from/to given address.
Reads or writes a halfword from/to given address.
Reads or writes a word from/to given address.
Reads or writes from/to given register.
Reads and displays all CPU registers.
Resets and halts the target CPU.
Enable or disable halting the target on semihosting error.
Enables semihosting.
Set semihosting I/O to be handled via Telnet port or GDB.
Sets the SWI number used for semihosting in ARM mode.
Sets the SWI number used for semihosting in thumb mode.
Set the arguments for the application.
Sets an instruction breakpoint at a given address.
Sleeps for a given time period.
Sets the JTAG speed of J-Link / J-Trace.
Performs one or more single instruction steps.
Undo target configuration for SWO and disable it in J-Link.
Configure target for SWO and enable it in J-Link.
Prints the maximum supported SWO speed for J-Link and
Target CPU.
Prints the available SWO speed and its minimum divider.
Waits for target to halt code execution.
Writes to given IceBreaker register.
Selects the specified target device.
Note: Use command line option
Selects the target interface.
Note: Use command line option
Sets the JTAG speed of J-Link / J-Trace.
Note: For the initial connection speed, use command line
option -speed instead.
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
Explanation
Explanation
-device instead.
-if instead.
J-Link GDB Server