General Procedure - Segger J-Link User Manual

237
10.2

General procedure

By default, the J-Link DLL comes with a build-in device database that defines which device
names are known and therefore officially supported by the J-Link DLL and software that
uses the J-Link DLL. This list can also be viewed on our website:
List of supported target devices
It is possible to add new devices to the currently used DLL by specifying them in an XML
file, named JLinkDevices.xml . It is also possible to edit/extend an device from the built-
in device database via this XML file. The DLL is looking for this file in the same directory
where the J-Link settings file is located. The location of the settings file depends on the
IDE / software being used. For more information about where the settings file is located for
various IDEs and software that use the J-Link DLL, please refer to
Started with Various IDEs
J-Link / J-Trace (UM08001)
CHAPTER 10
.
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
General procedure
SEGGER Wiki: Getting