Segger J-Link User Manual page 181

181
Command
map illegal
map indirectread
map ram
map region
map reset
ProjectFile
ReadIntoTraceCache
ScriptFile
SelectTraceSource
SetAllowFlashCache
SetAllowSimulation
SetBatchMode
SetCFIFlash
SetCheckModeAfterRead
SetCompareMode
SetCPUConnectIDCODE
SetDbgPowerDownOnClose
SetETBIsPresent
SetETMIsPresent
SetFlashDLNoRMWThreshold
SetFlashDLThreshold
SetIgnoreReadMemErrors
SetIgnoreWriteMemErrors
SetMonModeDebug
SetResetPulseLen
SetResetType
SetRestartOnClose
SetRTTAddr
SetRTTSearchRanges
SetRTTTelnetPort
SetRXIDCode
SetSysPowerDownOnIdle
SetVerifyDownload
SetWorkRAM
ShowControlPanel
SilentUpdateFW
J-Link / J-Trace (UM08001)
CHAPTER 5
Description
Marks a specified memory region as an illegal memory area.
Memory accesses to this region are ignored.
Specifies an area which should be read indirect.
Specifies location of target RAM.
Specifies a memory region.
Restores the default mapping, which means all memory accesses
are permitted.
Specifies a file or directory which should be used by the J-Link
DLL to save the current configuration.
Reads the given memory area into the streaming trace instruc-
tion cache.
Set script file path.
Selects which trace source should be used for tracing.
Enables/Disables flash cache usage.
Enables/Disables instruction set simulation.
Enables/Disables batch mode.
Specifies CFI flash area.
Enables/Disables CPSR check after read operations.
Specifies the compare mode to be used.
Specifies an CPU IDCODE that is used to authenticate the debug
probe, when connecting to the CPU.
Used to power-down the debug unit of the target CPU when the
debug session is closed.
Selects if the connected device has an ETB.
Selects if the connected device has an ETM.
Specifies a threshold when writing to flash memory does not
cause a read-modify-write operation.
Set minimum amount of data to be downloaded.
Specifies if read memory errors will be ignored.
Specifies if write memory errors will be ignored.
Enables/Disables monitor mode debugging.
Defines the length of the RESET pulse in milliseconds.
Selects the reset strategy.
Specifies restart behavior on close.
Set address of the RTT buffer.
Set ranges to be searched for RTT buffer.
Set the port used for RTT telnet.
Specifies an ID Code for Renesas RX devices to be used by the J-
Link DLL.
Used to power-down the target CPU, when there are no trans-
missions between J-Link and target CPU, for a specified time
frame.
Specifies the verify option to be used.
Specifies RAM area to be used by the J-Link DLL.
Opens control panel.
Update new firmware automatically.
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
Command strings