Table of Contents
Advertisement
Available languages
Available languages
Safety data sheets
Material safety data sheet of the Océ toner - Continued
[121]
SAFETY DATA SHEET
Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II
Océ F3/F11Toner
6.
Accidental release measures
Personal precautions
Environmental precautions
Spill
Note: see section 8 for personal protective equipment and section 13 for waste disposal.
7.
Handling and storage
Handling
Storage
Specific uses
8.
Exposure controls/personal protection
Occupational exposure limits
Ingredient name
Carbon black
Respirable particulate
Inhalable particulate
Recommended monitoring
procedures
Exposure controls
Occupational exposure controls
Respiratory protection
Hand protection
Eye protection
Skin protection
Environmental exposure controls
9.
Physical and chemical properties
Physical state
Odour
Colour
pH
Boiling point
Melting point
Flash point
Explosion limits
Vapour pressure
Vapour density
Evaporation rate
Oxidising properties
Density
Viscosity
Solubility
Octanol/water partition coefficient
The content of this safety data sheet is subject to the disclaimer of liability on the
introduction page of this chapter. You can find the translations of the disclaimer in
the Safety data sheets section of the respective languages in this multilingual Safety
information.
208
Appendix A Safety data sheets
:
Avoid breathing dust. Refer to protective measures listed in sections 7 and 8.
:
Avoid dispersal of spilt material and runoff and contact with soil, waterways, drains and sewers.
:
Vacuum or sweep up spilled material with a damp rag. Avoid formation of dust.
:
Handle and open container with care. Avoid formation of dust. See information supplied on the label of the
tonerbottle and in the operator manual of the copier/printer.
Use with adequate ventilation. See operator manual or safety data sheet of the copier/printer.
:
Keep container tightly closed and sealed until ready for use. Store in accordance with local regulations.
: Keep container tightly closed to prevent dust formation. Handle with care. Avoid breathing dust.
Occupational exposure limits
ACGIH TLV (United States, 1/2008).
TWA: 3.5 mg/m³ 8 hour(s).
ACGIH TLV (United States).
TWA: 3 mg/m³
ACGIH TLV (United States).
TWA: 10 mg/m³
:
Not required.
: Use with adequate ventilation. See operator manual or safety data sheet of the copier/printer.
:
Not required in normal use.
:
Not required.
:
Not required.
:
Not required. Wash skin with soap and cold water.
:
Not required in normal use.
:
Solid. [Powder.]
:
Faint odour.
:
Black.
:
Not applicable.
: Not applicable.
:
approx. 50°C (softening point)
:
Not available.
:
Lower: 60 g/cm
3
: Not applicable.
:
Not available.
:
Not applicable.
:
Not available.
3
:
approx. 1000 kg/m
(bulk density).
:
Not available.
:
Insoluble in water.
: Not available.
Number
EN-262-b-NL
Date
22 September 2008
Page
2/4
Advertisement
Table of Contents
