Instructions For Safe Use - Oce VarioPrint 4110 User Manual

Instructions for safe use

Instructions for safe use
Océ designed products have been tested in accordance with the strictest international
safety standards. To help assure safe working with these products it is important that
you observe the following safety rules.
Maintenance
Do not remove any screws from fixed panels.
Do not carry out maintenance activities except for the parts and maintenance
materials mentioned in this manual.
Do not place any liquids on the machine.
Use maintenance materials or other materials for their original purpose only.
Keep maintenance materials away from children.
Do not mix cleaning fluids or other substances.
To avoid the risk of introducing hazards, all modifications to the equipment are
strictly reserved to properly qualified and trained service technicians.
Connection
Do not move the machine yourself, but contact your Océ Customer Service.
If for some reason you have to move the machine yourself, please make sure that
the mains power point has the right fuse capacity. See the Product safety data
sheet of the machine in this Safety manual for information about maximum
current/building fuse.
Do not bridge any mechanical or electrical circuit breakers.
Do not use an extension lead to connect the machine.
It is recommended to connect only those products which meet the (inter)national
product safety and radio frequency interference standards, and to use an
attachment cable as specified by Océ.
This equipment has not been designed for connection to an IT power system.
(An IT power system is a voltage network in which the neutral wire is not
connected to earth).
For equipment connected via a wall socket: locate the machine close to a wall
socket that is easily accessible.
For equipment connected via a fixed connection to the electricity grid: the
disconnect device in the fixed connection should be easily accessible.
Mains connection
Never connect the machine to a mains voltage deviating from the value as stated on
the power marking label. The power marking labels of the various modules are
located at the following places.
Print engine: at the back of the machine at the right-hand side of the place where
the mains cable enters the machine.
184 Chapter 18 Safety information (US)