Shutdown Procedure; Traveling (Driving) - JLG 400SJ Operation And Safety Manual

6. Turn key of SELECT switch to PLATFORM.
7. From Platform position POWER/EMERGENCY STOP
switch to ON, then push the ENGINE START switch to
the forward position until engine starts.
NOTE: Footswitch must be in released (up) position before
starter will operate. If starter operates with footswitch
in the depressed position, DO NOT OPERATE
MACHINE.

Shutdown Procedure

IF AN ENGINE MALFUNCTION NECESSITATES UNSCHEDULED SHUT-
DOWN, DETERMINE AND CORRECT CAUSE BEFORE RESUMING ANY
OPERATION.
1. Remove all load and allow engine to operate at low
speed setting for 3-5 minutes; this allows for further
reduction of internal engine temperature.
2. Position POWER/EMERGENCY STOP switch to OFF.
3. Turn key of MASTER switch to OFF position.
NOTE: Refer to Engine Manufacturer's manual for detailed
information.
3121216
4.4

TRAVELING (DRIVING)

See Figure 4-3., Grades and Sideslopes
DO NOT DRIVE WITH BOOM EXTENDED OR ABOVE HORIZONTAL
EXCEPT ON A SMOOTH, FIRM AND LEVEL SURFACE.
DO NOT DRIVE WITH HOODS RAISED OR UNLATCHED.
TO AVOID LOSS OF TRAVEL CONTROL OR UPSET ON GRADES AND
SIDESLOPES, DO NOT DRIVE MACHINE ON GRADES OR SIDESLOPES
EXCEEDING THOSE SPECIFIED ON MACHINE INFORMATION PLACARD
ON THE LEFT SIDE OF THE FRAME.
– JLG Lift –
SECTION 4 - MACHINE OPERATION
4-5