It8783F Super Io Configuration; Serial Port 0 Configuration - Nexcom NISE 300 User Manual

Chapter 4: BIOS Setup

IT8783F Super IO Configuration

This section is used to configure the serial ports.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
IT8783F Super IO Configuration
IT8783F Super IO Chip IT8783F

Serial Port 0 Configuration


Serial Port 1 Configuration

Serial Port 2 Configuration

Serial Port 3 Configuration

Serial Port 4 Configuration

Serial Port 5 Configuration

Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Super IO Chip
Displays the Super I/O chip used on the board.
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
Serial Port 0 Configuration
This section is used to configure serial port 0.
Set Parameters of Serial Port
O (COMA)
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Serial Port
Enables or disables the serial port.
Change Settings
Selects an optimal setting for the Super IO device.
Onboard Serial Port 0 Mode
Select this to change the serial port mode to RS232, RS422, RS485 or RS485
Auto.
Onboard Serial Port Max Baud Rate
Select this to change the max baud rate of the serial port.
64
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
Serial Port 0 Configuration
Serial Port [Enabled]
Device Settings IO=3F8h; IRQ=4;
Change Settings [IO=3F8h; IRQ=4;]
[RS232]
Onboard Serial Port 0 Mode
Onboard Serial Port Max Baud Rate [115200 bps]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Enable or Disable Serial Port
(COM)
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
NISE 300 User Manual