Nexcom NISE 300 User Manual page 76

Chapter 4: BIOS Setup
SATA Configuration
This section is used to configure the SATA drives.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
CFAST Empty
SATA2 Empty
MSATA TS32GMSA630
SATA1 Empty
Version 2.15.1236. Copyright (C) 2011 American Megatrends, Inc.
SATA Controller(s)
Enables or disables the SATA controller.
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
Enable or disable SATA Device.
(32.0GB)
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
SATA Mode Selection
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
RAID This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
62
NISE 300 User Manual