AudioCodes Mediant 1000 User Manual page 274


To configure outbound IP routing rules:
1. Open the Outbound IP Routing Table page (Configuration tab > VoIP menu > GW
and IP to IP submenu > Routing submenu > Tel to IP Routing).
The figure above displays the following outbound IP routing rules:
•
Rule 1 and Rule 2: For both rules, the called phone number prefix is 10, the
caller's phone number prefix is 100, and the call is assigned IP Profile ID 1.
However, Rule 1 is assigned a cheaper Cost Group than Rule 2, and therefore,
the call is sent to the destination IP address (10.33.45.63) associated with Rule 1.
•
Rule 3: For all callers (*), if the called phone number prefix is 20, the call is sent
to the destination according to IP Group 1 (which in turn is associated with a
Proxy Set ID providing the IP address).
•
Rule 4: If the called phone number prefix is 5, 7, 8, or 9 and the caller belongs to
Trunk Group ID 1, the call is sent to domain.com.
•
Rule 5: For all callers (*), if the called phone number prefix is 00, the call is
rejected (discarded).
•
Rule 6: If an incoming IP call pertaining to Source IP Group 2 with domain.com
as source host prefix in its SIP Request-URI, the IP call is sent to IP address
10.33.45.65.
•
Rule 7, Rule 8, and Rule 9: For all callers (*), if the called phone number prefix is
100, the call is sent to Rule 7 and 9 (belonging to Forking Group "1"). If their
destinations are unavailable and alternative routing is enabled, the call is sent to
Rule 8 (Forking Group "2").
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3. Configure the routing rules according to the table below.
SIP User's Manual 274
Mediant 600 & Mediant 1000
Document #: LTRT-83310