Cli-Based Management - AudioCodes Mediant 1000 User Manual

SIP User's Manual
4

CLI-Based Management

This section provides an overview of the CLI-based management and configuration relating
to CLI management.
The CLI can be accessed by using the RS-232 serial port or by using SSH or Telnet
through the Ethernet interface. Once logged into the CLI with your username and
password, you can configure the device by accessing one of the following modes:

Basic command mode: Provides general CLI commands, for example, to display
system information and activate debugging. This mode is accessed immediately after
you login to the CLI.

Enable command mode: Provides the configuration commands.
To access this mode, type the following:
# enable
# Password: <password>
This mode groups the commands under the following command sets:
•
configure-system: This contains the general and system related configuration
commands, for example, Syslog configuration. This set is accessed by typing the
following:
# configure system
•
configure-data: This contains the data-router configuration commands. This set is
accessed by typing the following:
# configure data
•
configure-voip: This contains VoIP-related configuration commands, for example,
SIP, VoIP network interfaces, and VoIP media configurations. This set is
accessed by typing the following:
# configure voip
Notes:
Version 6.4
•
For information on accessing the CLI interface, see 'Using CLI' on page
23.
•
For more information on using CLI and for a description of the CLI
commands, refer to the books: MSBG Data CLI Reference Guide and
MSBG VoIP and System CLI Reference Guide.
73
4. CLI-Based Management
March 2012