SIP User's Manual
18.6.5 Configuring Authentication
The Authentication page
port. Authentication is typically used for FXS interfaces, but can also be used for FXO
interfaces.
Notes:
To configure the Authentication Table:
1.
Set the parameter 'Authentication Mode' (AuthenticationMode) to Per Endpoint.
2.
Open the Authentication page (Configuration tab > VoIP menu > GW and IP to IP
submenu > Analog Gateway submenu > Authentication).
3.
In the 'User Name' and 'Password' fields corresponding to a port, enter the user name
and password respectively.
4.
Click Submit to apply your changes.
5.
To save the changes to flash memory, see 'Saving Configuration' on page 482.
Version 6.4
defines
a user name and password for authenticating each device
•
For configuring whether authentication is performed per port or for the
entire device, use the parameter AuthenticationMode. If authentication is
for the entire device, the configuration on this page is ignored.
•
If either the user name or password fields are omitted, the port's phone
number and global password (using the Password parameter) are used
instead.
•
After you click Submit, the password is displayed as an asterisk (*).
•
You can also configure Authentication using the ini file table parameter
Authentication (see 'Configuration Parameters Reference' on page 541).
Figure 18-24: Authentication Page
325
18. GW and IP to IP
March 2012