SIP User's Manual
Parameter
Web: Establish
Conference Code
EMS: Establish Code
[ConferenceCode]
Web/EMS: Conference ID
[ConferenceID]
Emergency Call Parameters
A.12.5.8
The emergency call parameters are described in the table below.
Parameter
EMS: Enable 911 PSAP
[Enable911PSAP]
Version 6.4
channels. These channels are obtained from the IP media module
(i.e., MPM module). Note that the device must be housed with MPM
module(s) to support three-way conferencing. The device supports
up to five simultaneous, on-board three-way conference calls.
Notes:
This parameter is applicable only to FXS and BRI interfaces.
Three-way conferencing using an external conference server is
supported only by FXS interfaces.
The on-board 3-way conference mode is not supported by Mediant
600.
When using an external conference server (options [0] or [1]), a
conference call with up to six participants can be established.
Defines the DTMF digit pattern, which upon detection generates the
conference call when three-way conferencing is enabled
(Enable3WayConference is set to 1).
The valid range is a 25-character string. The default is "!" (Hook-Flash).
Note: If the FlashKeysSequenceStyle parameter is set to 1 or 2, the
setting of the ConferenceCode parameter is overridden.
Defines the Conference Identification string (up to 16 characters). The
default value is 'conf'.
For 3-way conferencing using an external media server: The device
uses this identifier in the Conference-initiating INVITE that is sent to the
media server when Enable3WayConference is set to 1.
When using the Mediant 1000 Media Processing Module (MPM): To join
a conference, the INVITE URI must include the Conference ID string,
preceded by the number of the participants in the conference, and
terminated by a unique number.
For example: INVITE sip:4MyConference1234@10.1.10.10.
INVITE messages with the same URI join the same conference.
For example: ConferenceID = MyConference.
Table A-48: Emergency Call Parameters
Enables the support for the E911 DID protocol, according to the
Bellcore GR-350-CORE standard. This protocol defines signaling
between E911 Tandem Switches and the PSAP, using analog loop-
start lines. The FXO device can be installed instead of an E911
switch, connected directly to PSAP DID loop-start lines.
[0] = Disable (default)
[1] = Enable
Notes:
This parameter is applicable only to FXO interfaces.
This parameter can also be configured per Tel Profile, using the
TelProfile parameter.
671
A. Configuration Parameters Reference
Description
Description
March 2012