Installing The Starter Clutch; Installing The Generator - Yamaha Tracer MT09TRAH 2017 Service Manual

erator rotor "2" and hold the generator rotor.
b. When turning the starter clutch gear clock-
wise "A", the starter clutch and the starter
clutch gear should engage, otherwise the
starter clutch is faulty and must be replaced.
c. When turning the starter clutch gear counter-
clockwise "B", it should turn freely, otherwise
the starter clutch is faulty and must be re-
placed.
A
B
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30871

INSTALLING THE STARTER CLUTCH

1. Install:
• Starter clutch "1"
Starter clutch bolt
32 N·m (3.2 kgf·m, 23 lb·ft)
LOCTITE®
TIP
• Install the starter clutch so that the side of the
starter clutch roller assembly with the arrow
mark "a" is toward the generator rotor "2".
• While holding the generator rotor with the
sheave holder "3", tighten the starter clutch
bolts.
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
a
GENERATOR AND STARTER CLUTCH
EAS30872
1

INSTALLING THE GENERATOR

1. Install:
• Woodruff key
• Generator rotor
• Washer
• Generator rotor bolt
2
TIP
• Clean the tapered portion of the crankshaft and
the generator rotor hub.
• When installing the generator rotor, make sure
the woodruff key is properly seated in the key-
way of the crankshaft.
• Lubricate the washer with engine oil.
• Lubricate the generator rotor bolt threads and
washer mating surfaces with engine oil.
2. Tighten:
• Generator rotor bolt "1"
TIP
While holding the generator rotor "2" with the
sheave holder "3", tighten the generator rotor
bolt.
3
1
2
5-32
2
New
Generator rotor bolt
75 N·m (7.5 kgf·m, 54 lb·ft)
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
1
3
2