Yamaha Tracer MT09TRAH 2017 Service Manual page 103

1. Front brake hose assembly 1
2. Front wheel sensor lead
3. Clamp
4. Bracket
5. Brake caliper (right)
6. Front fender
7. Reflector (left and right)
8. Brake caliper (left)
9. Clamp
10.Clamp
A. Make sure that the bracket has contact with
the axle bracket, and install it.
B. Install the brake pipe so that it contacts the
projection on the brake caliper.
C. Install the clamp at the position where the
distance between the upper end of the metal
fittings of the brake hose and bottom side of
the clamp is 25–45 mm (0.98–1.77 in).
D. Route the front wheel sensor lead along the
front brake hose as shown in the illustration.
E. Route the front wheel sensor lead through
the right side of the vehicle along the brake
hose.
F. The blue paint should face to the outside of
the vehicle.
G. Install the brake hose from the hydraulic unit
so that the brake pipe touches the projection
on the brake caliper.
Install the brake hose to the brake caliper
(right) so that it aligned with the direction of
the brake pipe from the hydraulic unit.
H. Insert the grommet of the front wheel sensor.
I. Right side of the vehicle
J. Route the front wheel sensor lead in front of
the vehicle along the brake hose, and clamp
the white tape portion. The center line should
be within this area.
K. 45
L. Vehicle forward direction
M. Inside of the vehicle
N. Insert the clamp into the T-stud of the
bracket.
O. Route the front wheel sensor lead in front of
the vehicle against the brake hose.
P. Make sure that the clamp has contact with
the bracket in the right rotation direction as
shown in the illustration, and install it.
Q. Same for four clamps
R. Insert the clamp securely.
S. Make sure the clamp is engaged by 3 or
more notches.
Engage the claws so that they face toward
the rear side of the vehicle.
T. When installing the reflector, make sure that
the reflector (left and right) contacts the brake
caliper.
2-62
CABLE ROUTING