Fault code No. P0202
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Actuation
Procedure
Probable cause of malfunc-
Item
tion and check
1
Connection of fuel injector #2
coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
2
Defective fuel injector #2.
3
Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
4
Connection of sub-wire har-
ness coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
5
Wire harness continuity.
P0202
Fuel injector #2: malfunction in fuel injector #2.
Able to start engine (depending on the number of faulty cylinders)
Able to drive vehicle (depending on the number of faulty cylinders)
37
Actuates fuel injector #2 five times at one-second intervals.
The "check" indicator on the Yamaha diagnostic tool screen comes on
each time the fuel injector is actuated.
Disconnect the fuel pump coupler. Check that fuel injector #2 is actuated
five times by listening for the operating sound.
Maintenance job
Improperly connected Con-
nect the coupler securely or
replace the wire harness.
Measure the fuel injector resis-
tance.
Replace if out of specification.
Refer to "CHECKING THE
FUEL INJECTORS" on page
8-174.
Improperly connected Con-
nect the coupler securely or
replace the wire harness.
Improperly connected Con-
nect the coupler securely or
replace the sub-wire harness.
Open or short circuit Replace
the wire harness.
Between fuel injector coupler
and sub-wire harness coupler.
green/black–green/black
red/blue–red/blue
Between sub-wire harness cou-
pler and ECU coupler.
green/black–green/black
Between sub-wire harness cou-
pler and relay unit coupler.
red/blue–red/blue
8-57
FUEL INJECTION SYSTEM
Confirmation of service com-
Execute the diagnostic mode.
(Code No. 37)
Operating sound Go to item
7.
No operating sound Go to
item 2.
Execute the diagnostic mode.
(Code No. 37)
Operating sound Go to item
7.
No operating sound Go to
item 3.
Execute the diagnostic mode.
(Code No. 37)
Operating sound Go to item
7.
No operating sound Go to
item 4.
Execute the diagnostic mode.
(Code No. 37)
Operating sound Go to item
7.
No operating sound Go to
item 5.
Execute the diagnostic mode.
(Code No. 37)
Operating sound Go to item
7.
No operating sound Go to
item 6.
pletion