Checking The Sidestand; Lubricating The Sidestand; Checking The Centerstand; Lubricating The Centerstand - Yamaha Tracer MT09TRAH 2017 Service Manual

2. Adjust:
• Installed shift rod length
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift pedal position.
Direction "a"
Installed shift rod length increases.
Direction "b"
Installed shift rod length decreases.
c. Tighten both locknuts.
d. Make sure the installed shift rod length is
within specification.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30650

CHECKING THE SIDESTAND

1. Check:
• Sidestand operation
Check that the sidestand moves smoothly.
Rough movement  Repair or replace.
EAS30651

LUBRICATING THE SIDESTAND

Lubricate the pivoting point, metal-to-metal mov-
ing parts and spring contact point of the sides-
tand.
Recommended lubricant
Lithium-soap-based grease
a a
1
2 1
b a a
a b b
PERIODIC MAINTENANCE
EAS30856

CHECKING THE CENTERSTAND

1. Check:
• Centerstand operation
Check that the centerstand moves smoothly.
Rough movement  Repair or replace.
EAS30857

LUBRICATING THE CENTERSTAND

Lubricate the pivoting point and metal-to-metal
moving parts of the centerstand.
Recommended lubricant
Lithium-soap-based grease
EAS30652

CHECKING THE SIDESTAND SWITCH

Refer to "ELECTRICAL COMPONENTS" on
page 8-149.
EAS30653

CHECKING THE FRONT FORK

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Check:
• Inner tube
Damage/scratches  Replace.
• Front fork leg
Oil leaks between inner tube and outer tube
 Replace the oil seal.
3. Hold the vehicle upright and apply the front
brake.
4. Check:
• Front fork operation
Push down hard on the handlebar several
times and check if the front fork rebounds
smoothly.
Rough movement  Repair.
Refer to "FRONT FORK" on page 4-76.
EAS30806

ADJUSTING THE FRONT FORK LEGS

The following procedure applies to both of the
3-21