Yamaha Tracer MT09TRAH 2017 Service Manual page 227

TIP
Be sure to bleed the front fork leg of any residual
air.
14.Measure:
• Front fork leg oil level "a"
(from the top of the outer tube, with the outer
tube fully compressed and without the fork
spring)
Out of specification  Correct.
Level (left)
174 mm (6.9 in)
Level (right)
175 mm (6.9 in)
15.Install:
• Fork spring (left side) "1"
• Spacer (left side) "2"
• Locknut (left side) "3"
• Washer (left side) "4"
• Cap bolt (left side) "5"
(along with the O-ring
2
4
3
5
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the rod puller and rod puller attach-
ment.
b. Install the fork spring.
TIP
Install the fork spring with the smaller diameter
"a" facing up "A".
)
New
1
c. Install the locknut all the way onto the damper
rod assembly.
d. Install the rod puller and rod puller attach-
ment.
e. Install the spacer.
f. Install the fork spring compressor.
g. Press down on the spacer with the fork spring
compressor "1".
h. Pull up the rod puller and install the rod holder
"2" between the locknut "3" and the spacer
"4".
Rod puller
90890-01437
Universal damping rod bleeding
tool set
YM-A8703
Rod puller attachment (M10 long)
90890-01578
Universal damping rod bleeding
tool set
YM-A8703
Fork spring compressor
90890-01441
Fork spring compressor
YM-01441
Rod holder
90890-01434
Damper rod holder double ended
YM-01434
TIP
Use the side of the rod holder that is marked "B".
4
1
i. Remove the rod puller and rod puller attach-
4-84
FRONT FORK
3
2