Yamaha Tracer MT09TRAH 2017 Service Manual page 101

1. Rear wheel sensor coupler
2. Negative battery lead coupler
3. Positive battery terminal
4. Negative battery lead
5. Radiator fan motor relay
6. Negative battery terminal
7. Fuse box
8. Relay unit
9. Turn signal/hazard relay
10.Clamp
11.Rear turn signal light coupler (left/right)
12.Tail/brake light coupler
13.Tail/brake light lead
14.Yamaha diagnostic tool coupler
15.Starter relay
16.Battery
17.Positive battery lead
18.Shift switch coupler (option)
19.Battery box
20.Starter motor lead
21.Stator coil lead
22.Wire harness (to rectifier/regulator)
23.Wire harness
A. Position the rear wheel sensor coupler under
the negative battery lead.
B. Position the negative battery lead coupler
under the negative battery lead.
C. Install the rubber bracket of the radiator fan
motor relay in the battery box. Make sure to
route the lead under the relay.
D. Fasten the fuse box onto the battery box.
E. Install the rubber bracket of the relay unit in
the battery box.
F. Install the rubber bracket of the turn sig-
nal/hazard relay in the battery box.
G. Install the clamp into the hole in the battery
box.
H. Connect each rear turn signal coupler to the
coupler with the same color. After connecting
the license plate light coupler, store the rear
turn signal light coupler (left/right) furthest to
the bottom of the vehicle. After connecting
the other couplers, store them below the
tail/brake light lead.
I. Route the tail/brake light lead, turn signal
light lead, and license plate light lead through
the cutout of the battery box. The order of the
leads does not matter.
J. Fasten the wire harness side of the tail/brake
light coupler to the battery box.
K. Route the turn signal light lead, and license
plate light lead through the cutout of the bat-
tery box. The order of the leads does not
matter.
L. Route the Yamaha diagnostic tool coupler
lead at the bottom of the battery box.
M. Insert the Yamaha diagnostic tool coupler to
the battery box.
N. Install the rubber bracket of the starter relay
in the battery box.
O. Instructional drawing for routes in the front of
the battery
P. Fasten the crankshaft position sensor coupler
of the wire harness with tape.
2-60
CABLE ROUTING