Yamaha Tracer MT09TRAH 2017 Service Manual page 228

ment.
j. Install the washer and cap bolt, and then fin-
ger tighten the cap bolt.
EWA13670
WARNING
Always use a new cap bolt O-ring.
k. Hold the cap bolt "5" and tighten the locknut
"3" to specification.
Front fork cap bolt locknut
15 N·m (1.5 kgf·m, 11 lb·ft)
l. Remove the rod holder and fork spring com-
pressor.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
16.Install:
• Fork spring (right side) "1"
• Spacer (right side) "2"
• Locknut (right side) "3"
• Damper adjusting rod "4"
• Washer (right side) "5"
• Cap bolt (right side) "6"
(along with the O-ring
2
5
3
6
4
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the rod puller and rod puller attach-
ment.
b. Install the fork spring.
TIP
Install the fork spring with the smaller diameter
"a" facing up "A".
5
3
)
New
1
c. Install the locknut all the way onto the damper
rod assembly.
d. Install the rod puller and rod puller attach-
ment.
e. Install the spacer.
f. Install the fork spring compressor.
g. Press down on the spacer with the fork spring
compressor "1".
h. Pull up the rod puller and install the rod holder
"2" between the locknut "3" and the spacer
"4".
Rod puller
90890-01437
Universal damping rod bleeding
tool set
YM-A8703
Rod puller attachment (M10 long)
90890-01578
Universal damping rod bleeding
tool set
YM-A8703
Fork spring compressor
90890-01441
Fork spring compressor
YM-01441
Rod holder
90890-01434
Damper rod holder double ended
YM-01434
TIP
Use the side of the rod holder that is marked "B".
4
1
i. Remove the rod puller and rod puller attach-
4-85
FRONT FORK
3
2