Yamaha Tracer MT09TRAH 2017 Service Manual page 561

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
05 Air temperature
06 Coolant temperature
07 Rear wheel vehicle speed
pulses
08 Lean angle sensor
• Upright
• Overturned
09 Fuel system voltage
(battery voltage)
13 Throttle position sensor sig-
nal 2
• Fully closed position
• Fully open position
14 Accelerator position sensor
signal 1
• Fully closed position
• Fully open position
15 Accelerator position sensor
signal 2
• Fully closed position
• Fully open position
16 Front wheel vehicle speed
pulses
Item
Displays the air temperature. Compare the actually mea-
When engine is cold: Dis-
plays temperature closer to
air temperature.
When engine is hot: Displays
current coolant temperature.
Rear wheel speed pulse
0–999
Lean angle sensor output
voltage
0.4–1.4
3.7–4.4
Fuel system voltage
Approximately 12.0
9–23
94–108
12–22
97–107
10–24
95–109
Front wheel speed pulse
0–999
9-14
Tool display Procedure
sured air temperature with
the tool display value.
Compare the actually mea-
sured coolant temperature
with the tool display value.
Check that the number
increases when the rear
wheel is rotated. The number
is cumulative and does not
reset each time the wheel is
stopped.
Remove the lean angle sen-
sor and incline it more than
65 degrees.
Set the start/engine stop
switch to " ", and then com-
pare the actually measured
battery voltage with the tool
display value. (If the actually
measured battery voltage is
low, recharge the battery.)
Check with throttle valves
fully closed.
Check with throttle valves
fully open.
Check with throttle grip fully
closed position.
Check with throttle grip fully
open position.
Check with throttle grip fully
closed position.
Check with throttle grip fully
open position.
Check that the number
increases when the front
wheel is rotated. The number
is cumulative and does not
reset each time the wheel is
stopped.