Yamaha Tracer MT09TRAH 2017 Service Manual page 81

1. Radiator cap
2. Radiator
3. Radiator fan
4. Radiator outlet hose
5. Thermostat assembly
6. Water jacket joint
7. Coolant reservoir
8. Radiator inlet hose
A. Install the radiator outlet hose with its white
paint mark facing inward.
B. Install the radiator outlet hose up to the base
of the bend in the radiator pipe.
C. Point the hose clamp installation bolt inward.
D. Point the end of the hose clip downward.
E. Align the yellow paint mark of the radiator
outlet hose with the rib of the thermostat
assembly, and then install it.
F. Install the radiator outlet hose so that the tip
of the hose contacts the rib of the thermostat
assembly.
G. Install the radiator inlet hose so that the tip of
the hose contacts the rib of the water jacket
joint.
H. Install the radiator inlet hose with its yellow
paint mark facing downward.
I. Point the hose clamp installation bolt upward.
J. Install the radiator inlet hose up to the base of
the bend in the radiator pipe.
K. Install the radiator inlet hose with its white
paint mark facing inward.
L. Install the radiator hose up to the base of the
bend in the radiator pipe.
M. Point the end of the clip outward.
N. Install the coolant reservoir hose up to the
base of the bend in the radiator pipe.
O. Point the end of the clip rearward.
P. Install the grommet on the coolant reservoir
drain hose to the hole in the coolant reservoir
cover.
Q. Place the lock of the hose clamp within the
area shown in the illustration, placing as
close to the center as possible.
R. 90
S. Point the tip of the clamp rearward.
2-40
CABLE ROUTING