Yamaha Tracer MT09TRAH 2017 Service Manual page 545

Result
Neutral position
Continuity
Positive tester probe
sky blue "1"
Negative tester probe
Sensor terminal "a"
1st position
Continuity
Positive tester probe
white "2"
Negative tester probe
Sensor terminal "b"
2nd position
Continuity
Positive tester probe
pink "3"
Negative tester probe
Sensor terminal "c"
3rd position
Continuity
Positive tester probe
yellow/white "4"
Negative tester probe
Sensor terminal "d"
4th position
Continuity
Positive tester probe
white/red "5"
Negative tester probe
Sensor terminal "e"
5th position
Continuity
Positive tester probe
orange "6"
Negative tester probe
Sensor terminal "f"
6th position
Continuity
Positive tester probe
gray "7"
Negative tester probe
Sensor terminal "g"
ELECTRICAL COMPONENTS
EAS30681
CHECKING THE FUEL INJECTORS
The following procedure applies to all of the fuel
injectors.
1. Remove:
• Fuel injector
Refer to "THROTTLE BODIES" on page 7-5.
2. Check:
• Fuel injector resistance
Out of specification  Replace the fuel injec-
tor.
Resistance
12.0 
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Disconnect the fuel injector coupler from the
fuel injector.
b. Connect the digital circuit tester () to the fuel
injector coupler as shown.
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
• Positive tester probe 
Injector terminal "1"
• Negative tester probe 
Injector terminal "2"
c. Measure the fuel injector resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
8-174