Cobalt Digital Inc 9902-DC-4K Product Manual page 52

3
Table 3-1 9902-DC-4K Function Menu List — continued
• Card Check and Restore Utilities
• Card IP Physical Port Select Control
• Card IP Setup Controls
• Card SNMP MIB Download
3-28
9902-DC-4K Function Menu List and Descriptions
(continued)
Memory Test allows all cells of the card FPGA memory to be tested.
This control should only be activated under direction of
product support. Exercising the memory test is not part of
normal card maintenance.
Restore from SD Card allows card rendered inoperable to be restored
using an SD memory card fitted to the card internal SD slot.
Product support must be contacted prior to performing this
operation. Use of any SD card not supplied by support can
corrupt the card.
The Networking sub-tab provides a dedicated Ethernet connection to
card control and monitoring via a rear module Ethernet port. (This IP
interface is entirely independent and separate from the card's DashBoard
frame-based remote control/monitoring interface.)
(Dedicated card control using IP has not been fully implemented at this
release. Some functions may be reserved.)
Allows card dedicated IP interface (as set below) to use frame
communications or dedicated rear I/O module Ethernet RJ-45 port.
Note: • Frame net connection allows cards with per-card Ethernet
connection to connect with network via a shared frame Ethernet
port instead of per-card dedicated Ethernet connectors on the
card's rear module. Frame net connection is available only on
certain frame models.
• Card slot must be fitted with a rear I/O module equipped with an
Ethernet connector in order to use Rear I/O selection.
Provides controls for setting up card dedicated IP interface.
• Addressing Mode selsects either DHCP or static.
Where Static is selected, standard IP fields allow entry of Address,
Subnet Mask, and Default Gateway.
Where supported, allows card SNMP MIB files to be downloaded and
saved using user-configured name.
9902-DC-4K PRODUCT MANUAL 9902DC4K-OM (V1.5)