Cobalt Digital Inc 9902-DC-4K Product Manual page 14

1
OGCP-9000 Control Panel
or
OGCP-9000/CC Control Panel
9902-DC-4K Card
Computer
with NIC
Note: • To communicate with DashBoard™ or a Remote Control Panel, the frame must have a Network Controller card installed.
• DashBoard™ and the Remote Control Panels provide network control of the 9902-DC-4K as shown. The value displayed
at any time on the card, or via DashBoard™ or a Control Panel is the actual value as set on the card, with the current value
displayed being the actual value as effected by the card. Parameter changes made by any of these means are universally
accepted by the card (for example, a change made using the DashBoard™ controls will change the setting displayed on
a Control Panel).
1-10
The DashBoard™ software can be downloaded from the Cobalt Digital Inc.
website: www.cobaltdigital.com (enter "DashBoard" in the search window).
The DashBoard™ user interface is described in Chapter 3,"Setup
Instructions".
Remote Control Panel
Limited, non-abstract control of the 9902-DC-4K can be
effected using a control panel. This control is typically limited
to launching card presets and other non-abstract operations.
20-Slot Frame with Network Controller Card
DashBoard™ Remote Control
Using a computer with
DashBoard™ installed,
9902-DC-4K card can be
remotely controlled over a LAN
Figure 1-3 9902-DC-4K User Control Interface
Note: Download a copy of this guide by clicking on the Support>Reference
Documents link at www.cobaltdigital.com and then select DashBoard
Remote Control Setup Guide as a download, or contact Cobalt
Contact Cobalt Digital Inc. (p. 1-14).
9902-DC-4K PRODUCT MANUAL
9902-DC-4K Functional Description
In conjunction with a frame equipped
with a Network Controller Card,
9902-DC-4K card can be remotely
controlled over a LAN
LAN
®
as listed in
9902DC4K-OM (V1.5)