9902-Dc-4K Rear I/O Modules - Cobalt Digital Inc 9902-DC-4K Product Manual

2

9902-DC-4K Rear I/O Modules

Table 2-1 9902-DC-4K Rear I/O Modules
9902-DC-4K Rear I/O Module
RM20-9902DC4K-B
RM20-9902DC4K-C
2-4
Table 2-1 shows and describes the full assortment of Rear I/O Modules
specifically for use with the 9902-DC-4K.
Provides the following connections:
• Four SDI In BNCs (VID IN A thru VID IN D)
• Two 3G/HD-SDI Combined Video Out BNCs
• HDMI OUT Quadrant Combined Video/Audio Out
• ETHERNET 100/1000 BaseT Ethernet card
Note: Rear module Ethernet port provides additional
Provides the following connections:
• Four SDI In BNCs (VID IN A thru VID IN D)
• Two 3G/HD-SDI Combined Video Out BNCs
• COMM/GPIO port.
• ETHERNET 100/1000 BaseT Ethernet card
Note: Rear module Ethernet port provides additional
9902-DC-4K PRODUCT MANUAL
Installing a Rear I/O Module
Description
(SDI OUT 1 and SDI OUT 2)
connector
communications connector
card communication functions separate from
frame-based (i.e., DashBoard) remote control.
Rear module Ethernet port is not required to
be used for normal card DashBoard remote
control. Ethernet port control/monitoring
functions are described in Chapter 3, Setup
Instructions.
(SDI OUT 1 and SDI OUT 2)
communications connector
card communication functions separate from
frame-based (i.e., DashBoard) remote control.
Rear module Ethernet port is not required to
be used for normal card DashBoard remote
control. Ethernet port control/monitoring
functions are described in Chapter 3, Setup
Instructions.
9902DC4K-OM (V1.5)