Table of Contents
Advertisement
Installation -
Installation flanges
menu
Installation - Ambient
conditions menu
Installation -
Channels menu
Installation - Analog
and digital outputs
menu
Installation - Save
settings menu
102
Make the following settings:
Total flange path length
Concentration in flanges
Step
Procedure
7
Leave the other settings unchanged.
8
Click on "Next".
The Installation - Ambient conditions menu (see page 69) is dis-
played.
Step
Procedure
9
Leave all values unchanged.
10
Click on "Next".
The Installation - Channels menu (see page 70) is displayed.
Step
Procedure
11
Leave all values unchanged.
12
Click on "Next".
The Installation - Analog and digital outputs menu (see page 72) is
displayed.
Step
Procedure
13
Leave all values unchanged.
14
Click on "Next".
The Installation - Save settings menu (see page 74) is displayed.
Step
Procedure
15
Check all the settings.
If...
a setting is incorrect
all settings are correct
Operating instruction LS4000 for NH
0 (zero) m
0 (zero) %
then...
the configuration routine must be repeat-
ed.
To repeat the adjustment of the configura-
tion, click on "Cancel". All changes are dis-
carded. The Installation procedure menu is
displayed. Repeat the configuration rou-
tine.
Click on "Save".
The settings are saved. The Main menu is
displayed. The analyzer is ready for calibra-
tion.
and H
O
3
2
OI/LS4000/NH3/H2O-EN
Advertisement
Table of Contents
