Setting Up Mt180; Connecting Power; Identifying Led Indicator Lights - Unitech Tashi User Manual

A versatile multi-function terminal

Hide thumbs Also See for Tashi:

Table of Contents

Setting up MT180

Connect power to MT180 through the following:

Connect the AC Adapter into MT180's DC Connector Port (1). Plug the AC Adapter into an

electrical outlet (2).

MT180 automatically starts when the AC Adapter connects to an external power source. The

welcome screen appears before MT180 runs the module checking process.

NOTE:

MT180 comes with an antitheft sensor inside the back panel. To setup MT180 before

installation, disable the alarm buzzer through one of the following:

1. Attach a magnet behind the sensor on the back panel.

2. Disable the antitheft function in the MT180 firmware (See Advanced Setting on

page 15).

3. Open the case and short circuit pin2 and pin3 of the J5 connector.

NOTE:

When MT180 is installed or used, be sure that you set the backup battery switch to the

left to power ON MT180; if you do not use MT180 over a long period of time, please

right switch OFF the battery switch located above the terminal block to save the

backup battery power.

MT180 contains three LED indicators. For detailed descriptions, refer to the following:

Indicator Light

Blinking Yellow

Solid Yellow

Solid Green

Solid Red

CPU normal operation.

Terminal crash.

Operation success.

For example: Swipe card success and enter the password success.

Error occurred during operation.

For example: Invalid card.

Description

Table of Contents