Table of Contents
Advertisement
Using Proximity Reader
MT180 features a standard proximity reader, which
is compatible with all 125kHz EM, 125kHz HID, and
13.56MHz MiFare cards.
Utilize MTTool to add a card through the following:
1.
Connect MT180 to a computer network. See
Establishing Terminal-PC Connection on
page 3.
2.
Execute MTTool on the computer.
3.
Enter the correct IP address and port num-
ber. Click Connect.
4.
Follow MT180 onscreen instructions to enter
the Card Info Query option. See General
Settings on page 12.
Swipe the card over the Proximity Reader.
MT180 beeps three times.
The screen displays Invalid Card with the
card number.
5.
In MTTool, under the SysSet2 tab, in the
Card Setting box input the card number, user name, group number, password and etc.
6.
Click Add a Card No. The status bar at the bottom of the MTTool screen displays Successful
terminal response informing that MTTool has successfully send the card to MT180.
NOTE:
When adding a card, it is necessary to at least fill in the card number, user name, group
number and password. Otherwise, a prompt appears to ask for this specific informa-
tion.
Utilize JanitorLite to add a card through the following:
1.
Connect MT180 to a computer network. See Establishing Terminal-PC Connection on page 3.
2.
Enable Unitech MT Service in the Control Panel.
3.
Click start
6
Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
All Programs
JanitorLite
JanitorLite.
Swipe card here
Advertisement
Table of Contents
