Table of Contents
Advertisement
This chapter introduces MT180's general and advanced settings.
General Settings
Press F1 to enter the terminal menu.
Press F5 to enter the General option.
Five options are available:
•
SysInfoQuery.
•
CardInfoQuery.
•
AddFinger.
•
ModifyCardPIN.
•
LongTimeDoor.
Enter the SysInfoQuery option to get the terminal information.
The five options are described through the following:
Sys Info Query
Location
Version&SNR
WorkMode
ModuleStatus
Card&Finger
Enter the CardInfoQuery option. Follow the onscreen prompt to swipe a card. The screen displays the
card number, user name, user number and group number preset in JanitorLite or MTTool.
Enter the AddFinger option. Follow the onscreen prompt to swipe a card. The screen displays an
Operation Notice. Follow the operation notice and place a finger on the fingerprint reader. Each card
allows to enroll a maximum of three fingerprints.
Enter the ModifyCardPIN option. Follow the onscreen prompt to swipe a card. The screen displays
Input old PIN. Using the numeric keypad to enter the card password and press F5 to confirm. The
screen displays Input new PIN. And Input again. The screen displays Modify Card PIN Success
upon successful modification.
12
Onscreen Setting
Displays the terminal location (#Controller 01, by default).
Displays the terminal firmware version and serial number.
Displays current operation mode (Access Mode, by default).
Displays the modules status of Flash1, Flash2, Finger, Reader1,
Reader2, Voice and Network. If the module operates normally, the
screen displays ok; if not, the screen displays error.
Displays the maximum card/fingerprint capacity and current card/finger-
print count.
Chapter 3
Description
>OperationSel<
>>General
X Advanced
Advertisement
Table of Contents
