Table of Contents
Advertisement
Using Fingerprint Reader
MT180 has an optional integrated Fingerprint reader
that enrolls and verifies and verify fingerprints. The
reader can store up to 7,000 fingerprint templates.
Each user is allowed to have a maximum of three
fingerprints.
NOTE:
Make sure the card is valid.
Enroll a fingerprint through the following:
1.
Press F1.
2.
Select General
3.
Swipe the card.
4.
Place a finger in the Fingerprint Reader and
adjust the finger placement according to the
onscreen instructions.
The screen may inform that the finger is too
high, too low, too left, too right, too small or
no finger. Remove and place the finger on
the fingerprint reader three times.
5.
Press F3 to enroll another fingerprint when the screen displays Collect finger OK. Continue?.
Press F5 to stop.
6.
After enrolling the finger on the fingerprint Reader three times, the screen displays CollectFin-
ger OK and return to the standby screen.
Utilize MTTool to collect fingerprints through the following:
1.
Connect MT180 to a computer network. See Establishing Terminal-PC Connection on page 3.
2.
Execute MTTool on the computer.
3.
Enter the correct IP address and port number. Click Connect.
4.
Under the SysSet2 tab, enter a card number in the Card No. field and click Card No Query.
Value FFFFFFFFFFFF displays in the Fingerprint Index field, which indicates empty finger-
print data for the card.
In the Card Serial No field, input the card number and click Get. Now fingerprint data can
extract from this card.
8
Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Add Finger.
Swipe Finger
Here
Advertisement
Table of Contents
