Setting Up Mt180; Connecting Power; Identifying Led Indicator Lights - Unitech TASHI MT180 User Manual

Versatile multi-function terminal

Hide thumbs Also See for TASHI MT180:

Table of Contents

Setting up MT180

This section describes how to turn on MT180 for the first time.

Follow these instructions to connect power to MT180.

Connect the adapter cable to the DC connector of MT180 (1), then plug the adapter into an

electrical outlet (2).

MT180 automatically powers on when the 12V DC power adapter is connected. MT180 wel-

come screen appears and then the terminal runs module checking process.

NOTE:

MT180 comes with an anti-theft sensor inside the rear panel. If you want to set up

MT180 before installation, do one of the following to disable the alarm buzzer.

1. Attach a magnet behind the sensor on the rear panel.

2. Disable Anti-theft function in MT180 firmware. (See Advanced Setting on page 15)

3. Open the case and short circuit pin2 and pin3 of the J5 connector.

MT180 is equipped with three LED indicators. Refer to the following table for detailed information.

Indicator Light

Blinking Yellow

Solid Yellow

Solid Green

Solid Red

CPU normal operation

Terminal crash

Operation success

For example, swipe card success, enter password success.

Error occurred during operation

For example, invalid card.

Description

Table of Contents