Remote Network:OpenVPNremote network.
Route:The route entries adjust the local routing table, telling it which network to route over
the VPN.
Client‐to‐Client: Client‐to‐Client can enable intercommunication between clients.
5.3.4 IPSec VPN
Internet Protocol Security (IPsec) is a protocol suite for secure Internet Protocol (IP)
communications by authenticating and encrypting each IP packet of a communication session.
IPSec can be configured to operate in two different modes, Tunnel and Transport mode. Use of
each mode depends on the requirements and implementation of IPSec.
IPSec VPN Server (Tunnel mode)
Tunnel mode is used to encrypt all traffic between secure IPSec Gateways, for example if you
have two CooVox IPPBX's and each acts as an IPSec Gateway for the hosts/IP phones behind it.
The WAN ports will be used to connect both CooVox systems to establish IPSec VPN connection,
now all PCs or IP phones on the LAN ports can communicate with each other on both sides via a
secure IPSec tunnel.
Navigate to web menu Network Settings‐>VPN Server. Check the IPSec radio button to configure
IPSec VPN server.
Enable: Tick the checkbox to enable IPSec VPN server.
Type:DefaultstoTunnel mode.
IPSec Local IP: CooVox WAN IP, which can be used to connect to the client network.
IPSec Password: Define a password for authentication of the IPSec client.
IPSec Remote IP: IPSec VPN client IP.The client uses this IP to connect to IPSec server.
IPSec Remote Network:Specify the IPSec VPN client LAN network address.