Opermode: Set the Opermode for FXO Ports.
ToneZone: Select the tone zone of your country.
Ring Timeout(s): FXO (FXS signaled) devices must have a timeout to determine if it should
hang up before the line is answered. This value can be tweaked to shortenhow long it takes
before DAHDI considers a non‐ringing line to have hung‐up.
Relax DTMF:Helps DTMF signal detection.
Send Caller ID
After: Certain countries (UK) have ring tones with different ring tones
(ring‐ring),which means the caller ID needs to be set later on, and not just afterthe first ring,
as per the default (1).
Echo Cancel:Enable/Disable software Echo Cancel algorithm.
Echo Training: Enabling echo training will cause the PBX system to mute the channel, send
an impulse, and use the impulse response to pre‐train the echo canceller so it can start out
with a much closer idea of the actual echo. Value may be "yes", "no", or a number of
milliseconds to delay before training (default = 400). This option does not apply to hardware
echo cancellers.
4.1.3 Global SIP Settings
Global SIP settings allow you to configure some general and advanced options for the IP‐PBX
system global SIP preferences. Navigate to web menu Advanced‐>Options‐>SIP Settings.
General
UDP Port: SIP over UDP service port. By default Zycoo IPPBX system uses UDP as SIP
transmission protocol. Port number can be changed here if required.
TCP Port: By ticking the "Enable" checkbox you can enable global SIP TCP support.To register
a SIP extension over TCP protocol, you'll have to select TCP transport on the extension
configure page, please refer to chapter 2.7.1.
TLS Port: By ticking the "Enable" checkbox you can enable global SIP TLS support. To register
a SIP extension over TLS protocol, you'll have to select TLS transport on the extension
configuration page, please refer to chapter 2.7.1.