Assigning Digital Outputs - Siemens SINAMICS V90 Operating Manual

signal. Then the current row displays grey. Otherwise, select "Cancel" to release the link.
The current row will then display white.
You can activate the checkbox in column "Set to 1" to forcely set the signal status to 1. For
the signal EMGS, it can be forcely set to 1 only when the drive formware version is V1.04
and higher.
Note
Signal P_TRG in PTI mode is reserved for future use.
4.2.5.2

Assigning digital outputs

You can assign digital outputs on the following panel:
12 signals in total can be freely linked to digital outputs. For more information, refer to Digital
outputs (DOs) (Page 72).
Click the cells with white background in the table. Select "Assign" to link the digital input with
the corresponding signal. Then the current cell displays grey.
SINAMICS V-ASSISTANT Online Help
Operating Manual, 02/2015, A5E32187373-003
Task navigation
4.2 Parameterizing
53